Connection and start-up
Switch on, press, weld
Welding program setting
•
Switch on the welding machine on the main
switch (2)
•
Select welding program or material/gas/wire
ADVANCED II
SYNERGIC
mm
Please read how this should
be selected on your welding
machine in the quick guide.
Select the setting that fits the
required wire and shielding
gas.
•
Adjust the welding current and secondary
parameters. Please read your quickguide
•
The machine is now ready to weld
WARNING
Voltage is present on the welding
wire when pressing the welding
hose trigger.
Software reading
•
Insert the SD card into
the machine's card
reader as shown in the
drawings.
•
Turn on the machine.
•
The display flashes
shortly with three lines
•
Wait until the set
current is displayed.
•
Turn off the machine
and remove the SD
card.
•
The machine is now
ready for use.
It is necessary to read software inside the new
control unit by means of a SD card, if the control
unit has been exchanged. The software can be
downloaded from http://migatronic.com/login
14
dimension. (Depending
on the model).