cecotec CONGA 1590 Manuel D'instructions page 49

return to the charging base. If the robot has not started cleaning from the charging base, it will
return to the starting point.
Note: If the room being cleaned is smaller than 10 m2, the robot will carry out the same cycle
twice.
Back home mode
This mode can be selected at any point of any cleaning cycle. Once it is activated, it will
automatically return to the charging base. If the robot has run out of battery, it will return to
the charging base with the LED indicator in red, if it returns with battery, the LED light will be
lit in blue.
Manual mode
Use the direction buttons to take the robot to the specific points where you want it to clean.
Magnetic restricted area: Use the magnetic strip provided to delimit a certain zone, to which
the robot will not be able to access and clean.
For example, place the magnetic strip from one door's frame to the other in order to forbid the
robot from crossing to a room.
5. CLEANING AND MAINTENANCE
Cleaning the side brushes
Make sure the side brushes are in good conditions.
If the bristles are deformed, introduce the side brush into hot water.
Clean them regularly in order to keep them in good conditions.
Cleaning Mix tank, dust tank and filters
It is suggested to empty the dust tank after each use.
Wash the primary filter each 15-30 days to lengthen their lifespan.
Dry completely the filters before placing them back in their position.
Do not expose the filters to direct sunlight.
The maximum service life of the primary and High-efficiency filter is 6 months.
1. Holding from the bottom of the dust tank, press the release button to take out the dust tank.
Img. 15
2. Open the dust tank cover.
Img. 16
3. Take the primary and high-efficiency filter out.
Img. 17
4. Open dust tank and empty it.
Img. 18
5. Take the primary andHigh-efficiency filter out.
Img. 19
Empty the dust tank.
ENGLISH
49