Cleaning And Maintenance; Battery Replacement And Charging - cecotec CONGA 2290 Manuel D'instructions

ENGLISH
without vacuuming.

7. CLEANING AND MAINTENANCE

Main brush and silicone brush
1. Turn the robot around and press the main brush's release button to take the cover out.
2. Take the main brush out and clean the compartment.
3. Clean the main brush with the provided tools and use water and soap if necessary.
4. Place the main brush in its position and fasten the cover's clip.
Recommendation: Replace the main brush every 6-12 months to ensure efficient operating
(depending on the frequency and type of use).
Fig. 20.
1. Main brush cover
2. Tab
3. Main brush
4. Compartment
Wet & dry tank
Open the robot's cover and take out the Wet & dry tank.
Fig. 21.
Lift the handle, remove the dust compartment, open it and empty it.
Fig. 22.
Clean the dust compartment with the cleaning brush and place it back in its position together
with the water compartment.
Fig. 23.
Introduce the Wet & dry tank back into the robot and close the top cover.
Fig. 24.
High-efficiency filter
Fig. 25.
Remove the high-efficiency filter, shake it to remove all the dust and clean it with the cleaning
brush.
Recommendations:
Replace the high-efficiency filter every 3 months depending on the frequency and type of use.
Clean the filter periodically with a brush to avoid blockage.
Side brush
Fig. 26.
Remove and clean the side brushes regularly.
34
Recommendation: In order to ensure a perfect cleaning, it is suggested to replace the side
brushes every 3 months, depending on the frequency and type of use.
Free-fall sensors
Fig. 27.
Clean the free-fall sensors with a soft cloth regularly.
Recommendation: Clean the camera regularly with a soft cloth.
Warning: Always transport the product turned off and in its original package.

8. BATTERY REPLACEMENT AND CHARGING

Do not use any other battery, power adapter or charging base than the one officially provided by
Cecotec.
Do not use non-rechargeable batteries.
Do not remove, dismantle or attempt to repair the battery or the charging base.
Do not place the charging base near heat sources.
Do not use a wet cloth to wipe any of the parts of this product.
If the robot is not going to be used for a long time, remove the battery from the product and
store it in a dry and safe place. It is suggested to charge the battery every month in order to
avoid damage to the battery.
Do not dispose of waste batteries at will. It is suggested to hand them over to professional
organizations for correct treatment.
9. TROUBLESHOOTING
Problem
1. The robot does not start up or does not clean.
2. The robot cannot charge or return to the charging base.
3. The robot does not work properly.
4. The robot emits a strange noise during cleaning.
5. The robot does not clean efficiently or dust leaks from the robot.
6. The robot could not connect to Wi-Fi.
7. The robot did not carry out the scheduled cleaning task.
8. The robot does not return to the charging base after spot cleaning or after changing
starting position.
9. The robot does not resume cleaning.
10. The robot is always offline.
11. Connection between the mobile phone and the robot failed.
12. Main brush error.
13. Left wheel error.
ENGLISH
35