cecotec CONGA 1590 Manuel D'instructions page 47

ENGLISH
Make sure the robot is switched on.
Entering the Schedule mode
Long press on the remote control for 3 seconds in order to enter the schedule mode. The
display will show the current day and time, the week day will flash and the time icon will light
up. If the current day has been already scheduled, the schedule button will be lit up.
Setting day
Use the direction buttons to select the day from Monday to Sunday, the selected day of the
week will flash.
Press the On/off button to confirm the day of the week and the selected day will turn steady.
Setting time
Once the day of the week has been confirmed, the hour digits will flash. Use the up and down
direction buttons to increase or decrease the hour and minutes and use the right and left
direction buttons to switch between hours and digits. The hours can be increased or decreased
by whole hours, the minutes by 30 minutes.
Confirmation or cancellation of schedule
After setting, aim the remote control at the robot and press the On/off button. A beep sound
will confirm the settings have been saved and the scheduled day will light up steady.
Press the Home button to cancel the schedule of the selected day. The prescheduled day will
turn off on the display and the next day will flash.
Follow the before steps to schedule the desire day again. Once the complete schedule has
been saved successfully, it will exit the schedule mode.
Cancel schedule settings
From the schedule settings, the scheduled day will light up and the non-scheduled ones will
flash. Press the direction buttons to select the day from Monday to Sunday.
Press the Home button to cancel the selected day. The display will show the next day.
Once the schedule has been cancelled, press the Schedule button to exit the schedule mode.
Check schedule
From the Standby mode or while the robot is on, press the Schedule button to check the
schedule. The scheduled days will be lit up steady except for the scheduled day closer to the
current day, which will flash.
Press the direction buttons to check the scheduled days.
Press the Schedule button on the remote control to quit the schedule-checking interface
manually.
Note: After 10 seconds of no remote-control operation, the display will automatically show
thecurrent time without need of using the remote control.
Recommendation: See the videotutorial at our YouTube channel for reference.
Cleaning modes
47