cecotec CONGA 1590 Manuel D'instructions page 45

ENGLISH
Press the On/off button to start Auto cleaning mode.
Wi-Fi indicator light
When entering network configuration (see before section), the white light will blink slowly.
When the device connects to the Wi-Fi, the white light will turn steady.
If the device fails to connect, the white light will blink faster.
Battery indicator light
The light will turn red when the battery is low.
The light will switch from blue to red alternately during charging.
The light will turn steady blue when it is totally charged.
Battery charging
Charging base
Place the charging base against the wall.
Remove any obstacle from around the charging base, following the safety distances shown
on the below picture:
Always turn the robot's power switch ON before placing it on the charging base.
Img. 12
Power connection
Plug one of the adapter ends into the robot's charging socket and the other to the power supply.
While the charging base is connected to the power supply, press the Home button on the
remote control for the robot to automatically return to the charging base
Img. 13
Note: If the robot's battery is low during operation, it will automatically return to the charging
base before running out.
Battery's service life
In order to lengthen the battery's service life:
Allow the robot to charge for 5 hours during the first charge.
Charge the robot as soon as possible when the battery is low.
If the robot is not going to be used for a long time: fully charge the battery, switch the robot off
and store it in a cool and dry place.
If the robot has been stored for a long time, allow it to charge for 5 hours before operating it
again.
Remote control
On/Off/Standby/Sleep
On/off/Standby
45