Cleaning And Maintenance; Main Brush - cecotec CONGA 3490 Mode D'emploi

ENGLISH
manually where the robot will not be allowed to clean. It starts cleaning outside the selected
area in Edge mode and then carries out an organized cleaning cycle in zig zag motion. The user
can set as many Restricted Areas as desired and choose the size of each of them.
10. Smart Area
This mode can only be activated with a previously saved map. This mode allows setting
specifi c areas that you want the robot to clean, without having to clean the whole surface. It
fi rst carries out a cleaning cycle in zig zag motion inside the delimited area. The user can set
as many Smart Areas as desired and choose the size of each of them.

7. CLEANING AND MAINTENANCE

MAIN BRUSH

1. Turn the robot around and press the main brush's release button to take the cover out.
2. Take the main brush out and clean the compartment.
3. Clean the main brush with the provided tools and use water and soap if necessary.
4. Place the main brush in its position and fasten the cover's clip.
Note: replace the main brush every 6-12 months to ensure effi cient operating (depending on
the frequency and type of use).
SILICONE BRUSH
To clean the silicone brush, follow the instructions on the previous section to remove it from
the robot and wash it with water and soap. Dry it thoroughly before installing it back to ensure
it operates effi ciently.
34
1. Main brush cover
1
2. Clip
2
3. Main brush
3
4. Compartment
4