cecotec CONGA 1590 Manuel D'instructions page 50

ENGLISH
Img. 20
6. Wash the dust tank and the primary filter using water.
Clean the high-efficiency filter with a brush, avoid washing it under water.
Img. 21
7. Install the primary filter and the high-efficiency filter into dust tank.
Cleaning sensors and wheels
Use a soft damp cloth to clean wheels and sensors.
Img. 22
Clean the charging terminals
Use a soft damp cloth to clean the charging terminals on the robot and on the charging base.
Use a dry cloth to wipe the charging terminals if the connection is poor.
Img. 23
Cleaning main brush kit
Remove the main brush kit from the product's main body, separate the cover fromthe brush
and clean them separately.
The brush can be washed in soap and water.
Img. 24
Warning: Do not introduce the main brush back in its place unless it is completely dry.
Battery removal and replacement
Remove the screws on the battery cover with a screw driver.
Remove the battery cover.
Remove the insulating tape on both sides of the battery and take it out.
Unplug the wire connector that links the battery to the robot.
Introduce the new battery and make sure the side with printed words is facing upwards.
Connect the cable from the battery to the robot.
Introduce the battery in the compartment.
Screw back the battery's cover.
Note: only use the original battery provided by Cecotec, the use of a different one could cause
product damage.
6. TROUBLESHOOTING
Error Reason
The power switch
1 is off while chaging
50
Solution Button dis-play
Check if the power The robot's display
switch is on or off and flashes quickly
turn it on
Beeps
1 long beep