Cleaning And Maintenance - cecotec CONGA 3390 Manuel D'instructions

ENGLISH

7. CLEANING AND MAINTENANCE

Main brush
Turn the robot around and press the main brush's release button to take the cover out.
Take the main brush out and clean the compartment.
Clean the main brush with the provided tools and use water and soap if necessary.
Place the main brush in its position and fasten the cover's clip.
Recommendation: Replace the main brush every 6-12 months to ensure efficient operating
(depending on the frequency and type of use).
Fig. 20.
1. Main brush cover
2. Tab
3. Main brush
4. Compartment
Wet&Dry tank
Open the robot's cover and take out the Wet & dry tank.
Open the Wet & dry tank, take the high-efficiency filter out and empty the dust.
Use a cleaning brush to clean the tank's inner part and reinstall the high-efficiency filter.
Introduce the tank back into the robot and close the top cover.
Cepillo Jalisco (brush)
To clean the Jalisco brush, follow the previous section's steps to take it out and clean it with
water.
Dry it thoroughly before assembling it back in order to ensure efficient operation.
High-efficiency filter
Fig. 21.
Remove the high-efficiency filter and shake it to remove all the dust.
Recommendations:
Replace the high-efficiency filter every 3 months depending on the frequency and type of use.
Clean the filter periodically with a brush to avoid blockage.
Wash the filter with lukewarm water, do not use detergents.
Side brush
Fig. 22.
Remove and clean the side brushes regularly.
Recommendation: In order to ensure a perfect cleaning, it is suggested to replace the side
brushes every 3 months, depending on the frequency and type of use.
Free-fall sensors
33