cecotec CONGA 1590 Manuel D'instructions page 43

ENGLISH
Battery
The remote control requires 2 x AAA-type batteries.
If the remote control is used near the charging base, the device might not recognise the
command.
Remove the batteries from inside the remote control if the robot is not going to be used for a
long time.
2. PRODUCT ASSEMBLY
Main brush and mops installation
Install the main brush into the robot's main body.
Install the main brush cover.
Adjust the mop to the tank's bottom part and press with your hand to make sure it is well
attached.
Img. 8
Wet & dry and dust tank installation
Open the water-filling opening, fill the tank with water and close it again following the arrows
on the picture.
Completely dry the connecting plates.
Introduce the dust tank into the compartment and lower the handle.
Introduce the Mix tank (water and dust) into the product's main body.
Img. 9
3. APP DOWNLOAD AND CONNECTION VIA WI-FI
In order to access all the robot's functions from anywhere, it is suggested to download the
Conga 1490/1590 App. You will be able to control the robot simple and efficiently while you
enjoy the excellence of cleaning.
App advantages:
Control your robot in an easy and intuitive way.
Activate the cleaning process from any point.
Carry out settings and daily scheduling.
Choose between its different cleaning modes: Auto, Gyro, Edge, Twice, Scrubbing, Area, Manual,
Random and Back home.
View how the robot creates an interactive map as it is cleaning.
Check the cleaned surface and the time taken.
43