Installing The Programming Unit; Installing The Fan Unit; Installing The Internal Panel - Stiebel Eltron LWE 40 Installation

INsTALLATIoN
Installation
5.3

Installing the programming unit

Note
Before installing the programming unit, the wiring be-
tween the control unit and fan and between the control
unit and power source must be complete.
f Pass the adaptor board through the cover frame and the
plate frame. The small tabs will subsequently point into the
wall.
f Position the adaptor board on the control unit so that the ter-
minal strips are not covered.
Note
The existing cable between the adaptor board and the
programming unit must not be extended.
f Screw the plate frame onto the flush box. The tabs must be
facing up and down.
f Position the cover frame on the plate frame.
f Place the programming unit in the cover frame aperture.
Carefully push the programming unit until it clicks into place
in the plate frame.
5.4

Installing the fan unit

f Remove the support elements from the wall mount casing.
f Clean the wall mount casing.
www.stiebel-eltron.com
f Push the fan unit into the wall mount casing so that the
bracket is inside at the bottom.
f Ensure that the fan unit does not get wedged or get hooked
on the wall mount casing.
f Push the fan unit as far as it will go into the wall mount
casing.
f Plug the fan unit plug into the plug-in connection.
f Click the plug into place.
5.5

Installing the internal panel

Standard internal panel
f If the internal panel is not open, carefully pull the internal
panel cover slightly back from the base plate.
LWE 40 | 33