General Information; Relevant Documents; Safety Instructions; Other Symbols In This Documentation - Stiebel Eltron LWE 40 Installation

INsTALLATIoN

General information

INsTALLATIoN
1. General information
This document is intended for qualified contractors.
Note
Read these instructions carefully before using the appli-
ance and retain them for future reference.
Pass on these instructions to a new user if required.
1.1

Relevant documents

326052 LWE 40 Operation
1.2

Safety instructions

1.2.1 Structure of safety instructions
KEYWORD Type of risk
Here, possible consequences are listed that may result
from failure to observe the safety instructions.
f Steps to prevent the risk are listed.
1.2.2 Symbols, type of risk
symbol Type of risk
Injury
Electrocution
Burns
(burns, scalding)
1.2.3 Keywords
KEYWord Meaning
DANGER Failure to observe this information will result in serious
injury or death.
WARNING Failure to observe this information may result in serious
injury or death.
CAUTION Failure to observe this information may result in non-seri-
ous or minor injury.
1.3

Other symbols in this documentation

Note
General information is identified by the adjacent symbol.
f Read these texts carefully.
symbol Meaning
Material losses
(appliance damage, consequential losses and environmen-
tal pollution)
Appliance disposal
www.stiebel-eltron.com
f This symbol indicates that you have to do something. The ac-
tion you need to take is described step by step.
1.4

Standardised output data

Information on determining and interpreting the specified stand-
ardised output data
Standard : EN 13141-8
The output data specifically mentioned in text, diagrams and
technical datasheets has been determined in line with the test
conditions specified in the standard shown in the heading of this
chapter.
Generally, these standardised test conditions will not fully meet
the conditions found at the installation site of the system user.
Depending on the chosen test method and the extent to which
the selected method deviates from the conditions specified in the
standard shown in the heading of this chapter, any deviations
can have a considerable impact. Additional factors that have an
influence on the test values are the measuring equipment, the
system configuration, the age of the system and the flow rates.
A confirmation of the specified output data can only be obtained
if the conditions applicable to the relevant test match those of the
standard shown in the heading of this chapter.
1.5

Units of measurement

Note
All measurements are given in mm unless stated oth-
erwise.
2.

Safety

Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
2.1

General safety instructions

We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
2.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
LWE 40 | 21