Tylo Prime Plus 99 Manuel D'utilisation page 8

Ceiling (Box 1):
• Lift the ceiling up and place it carefully on the four (4) wall panels as shown below.
• Note: Ensure that the electrical connections are placed through the ceiling and are not disconnected
when you put the ceiling into position slowly.
• Tip: To make it easier to pull cables through the ceiling slot, you can take small styropor blocks and
put them in several places between the ceiling and the wall panels so that the ceiling stays put. When
the cables have been pulled through, remove the styropor blocks and lower the ceiling onto the wall
panels.
• Using a step ladder, open the flaps in the ceiling and turn the wooden support 90º. This fixes the
ceiling securely to the wall panels and prevents the door panel from falling out.
Ceiling to the rear wall panel: (2) connections:
Lift the door panel at the top left of the rear external face
of the ceiling. You will see 4 connections labelled 1 – 4.
Fix each ceiling connection 1 – 4 to the corresponding
number.
Ensure that they are connected securely to each other.
After connecting close the ceiling flap.
Connection between the ceiling and the front wall panel:
• Lift the door on the top of the ceiling.
You will see four connections.
• Note: Connect white to black on the two black and white cables.
• Match the figures 4-8 to 4-8.
A dipole radio antenna is supplied with your infrared sauna for better FM
reception.
You will find the dipole antenna in the bag in the installation manual.
1. Take the dipole antenna (black wires) out of the bag in the installation
manual.
2. Open the cover on the top of the ceiling above the touch screen.
3. Connect the dipole antenna to the wire marked 7
4. Spread the wire out and pull it apart to improve FM radio reception.
Page 8