Tylo Prime Plus 99 Manuel D'utilisation page 7

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
Bench (Box 1):
• Push the bench seat downwards into the back panel with the junction box pointing
towards you.
• Tilt the bench against the back panel as shown below.
• Connect the S-1 electrical connector to the S-1 junction box.
• Fix the cover of the S-1 junction box with 2 Phillips screws.
• Connect the bench valance strip lights to the strip light connection in the connector
(Note: two connections may come out of the floor with some models. You only need
to connect one with this model.)
Lay the bench down and push it into the right place.
Front wall panel (Box 2):
• Push the front and glass sections into the corresponding slot on the floor.
Note: Only the right glass section will be fitted into the floor slot at this time. Push both side panels
to help secure the front panel.
Note: All panel parts are now connected but not secured.
Note: The ceiling is the final connection to secure the top end of the front panel.
Page 7

Publicité

Table des Matières
loading

Table des Matières