Control Panel Instructions; Light Functions - Tylo Prime Plus 99 Manuel D'utilisation

Control panel instructions:

Main current:
Press POWER to turn the sauna ON (AN) or OFF (AUS). If a red light comes on the sauna
is ON. If it is white the sauna is OFF.
Timer functions:
Press and hold down or in order to set the running time. You can also
run your finger up or down the timer to set it.
Timer 2:
Use this function with a pre-setting of up to 24 hours to set the sauna to come on later.
Temperature functions:
C F
1. Press to switch between and . C or F will light up to display the required units.
2. Press and hold or to set the required temperature.
Pressing once will increase or reduce the required setting in one degree intervals. You can also run your
finger over the temperature bar.
The central temperature display shows the actual sauna temperature.
3. Press to set the bench/ leg/ floor heat to ON or OFF. Red waves can be seen in heating mode and
white ones in OFF mode.
:

Light functions

1. Press Inside light to switch it ON or OFF.
2. Note: Outside light ON or OFF will not work with S series models.
Page 10