Tylo Prime Plus 99 Manuel D'utilisation page 4

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
Floor panel (Box 1): Put the floor panel on a level surface 8-16 cm from the wall panel and no more
than 152 cm away from a 230V socket.
Position the floor panel in such a way that the ceramic tiles/ IR floor heating point towards the front
of the sauna.
Note: Put the ceiling, bench valance and bench aside until the corresponding steps.
Rear wall panel (Box 2):
• Place the back panel section into the rear slot in the floor panel.
• The back panel section must be held upright until the right panel is fitted.
• Connect the electrical supply to the B-1 junction box.
• Fix the cover of the B-1 junction box with 2 Phillips screws.
Note – Put the front panel aside until the "Front wall panel" section.
Page 4

Publicité

Table des Matières
loading

Table des Matières