Porsche Mobile Charger Connect Guide D'installation page 19

Electric shock, fire
DANGER
Incorrectly installed electrical sockets can cause
electric shock or fire when the high-voltage battery is
charged using the vehicle charge port.
e Power supply testing and installation and initial
operation of the electrical socket for the charger
may only be carried out by a specialist electrician.
A specialist electrician is fully responsible for
compliance with the relevant standards and
regulations. Porsche recommends that you use
a certified Porsche service partner.
e The cross-section of the power cable for the
electrical socket must be defined in accordance
with the wire length and the locally applicable
regulations and standards.
e The electrical socket used for charging must be
connected to a separately fused electric circuit
that complies with local laws and standards.
e The charger is intended for use in private and
semi-public areas, e.g. private properties or
company car parks. In some countries, e.g. in Italy
1)
and New Zealand , mode 2 charging is
prohibited in public areas.
e Unauthorised persons, e.g. children playing or
animals, must not have access to the charger and
the vehicle during unsupervised charging.
e Please read the safety instructions in the
Operating Manual and Driver's Manual.
1) Time of printing. Further information is available from
your Porsche partner or from your local power supplier.
Information
In some countries, the connection of charging
equipment for electric vehicles must be reported to
the relevant authorities.
e Check obligation to notify the authorities and
legal conditions for operation before connecting
charging equipment.
Selecting Installation
Location
Electric shock, fire
DANGER
Improper use of the charger or non-compliance with
the safety instructions may result in short circuits,
electric shocks, explosions, fire or burns.
e Do not install the basic wall mount or the
charging dock in potentially explosive areas.
e Before installing the basic wall mount or the
charging dock, make sure that there are no
electric cables in the vicinity of the mounting
holes to be drilled.
e To reduce the risk of explosion - particularly in
garages - make sure that the control unit is
located at least 50 cm above the floor during
charging.
e Observe the locally applicable electrical installa-
tion regulations, fire protection measures, acci-
dent prevention regulations and escape routes.
The basic wall mount and the charging dock are
designed for indoor and outdoor installations. The
following criteria must be considered when selecting
a suitable installation location:
– Ideally, install the electrical socket and supply
line, the basic wall mount or the charging dock in
a covered area that offers protection from direct
sunlight and rain (e.g. in a garage).
Selecting Installation Location
– The distance of the electrical socket from the
floor and ceiling should be selected in compliance
with national regulations and standards so that
comfortable use is ensured.
– Do not install the basic wall mount or charging
dock under suspended or hanging objects.
– Do not install the basic wall mount or charging
dock in stables, livestock buildings or places
where ammonia gases occur.
– Install the basic wall mount or charging dock on a
smooth surface.
– In order to ensure secure fastening, check the
condition of the wall before installing.
– Install the basic wall mount or charging dock as
close as possible to the preferred parking position
of the vehicle. Take the orientation of the vehicle
into account.
– Install the basic wall mount or charging dock so
that it is not near pathways and the supply cables
do not cross any pathways.
– Install the basic wall mount or charging dock so
that the distance between the power plug and
power socket does not exceed the length of the
available supply cable.
Tools required
– Spirit level
– Power or hammer drill
– Screwdriver
DE
EN
FR
IT
ES
PT
NL
SV
FI
DA
NO
EL
CZ
HU
PL
HR
SR
SK
SL
ET
LT
LV
RO
BG
MK
17