Porsche Mobile Charger Connect Guide D'installation page 18

Safety
Safety
DE
EN
Country-specific regulations
FR
The following instructions must be observed when
performing work on the voltage system:
IT
– Each country has its own national standard,
ES
which ensures the safe design and functionality
of safety sockets and safety plugs. The use of
PT
such devices and systems presents a potential
hazard. It is therefore necessary that personnel
NL
have sufficient specialist knowledge and that the
SV
recognised technological rules are observed.
FI
Permitted operating modes
DA
In some countries, e.g. in China
only be operated using a permanent connection
NO
(Wallbox mode). Operation using a household or
EL
industrial electrical outlet (mode 2) is prohibited.
Ask your Porsche partner about country-specific
CZ
regulations.
HU
DANGER
PL
Conversion of the charger, e.g. from Wallbox mode to
HR
mobile mode 2, can cause short circuits, electric
shocks, explosions, fires or burns. Danger to life!
SR
e Once the charger has been installed for Wallbox
SK mode by qualified personnel, the charging system
must not be removed and operated in mobile
SL
mode.
If you remove the charger and operate it in mobile
ET
mode, you will be totally responsible for all
LT
resulting effects and consequences.
LV
RO
BG
1) Time of printing. Further information is available from
MK
your Porsche partner.
16
Qualification of personnel
The electrical installation may only be performed by
persons with appropriate electrical/electronic
knowledge and experience (electrically skilled
person). These persons must be able to provide proof
of the required specialist knowledge for the
installation of electrical systems and their
components through a passed examination.
Improper installation endangers your own life and
that of the electrical system user. With an improper
installation, you risk serious property damage,
e.g. due to fire. In the case of personal injury and
property damage, you are personally liable,
depending on the legal situation.
Requirements of electrically skilled persons:
1)
, the charger must
– Ability to select suitable tools, measuring devices
and, if necessary, personal protection equipment
– Ability to evaluate measurement results
– Ability to select electrical installation materials to
ensure the cut-off conditions
– Knowledge of IP codes
Danger to life through
– Knowledge about fitting of electrical installation
conversions
material
– Knowledge of type of power supply network
(TN, IT and TT system) and the associated
connection conditions (leadless earthing, protec-
tive earthing, necessary additional measures etc.)
– Knowledge of the general and special safety and
accident prevention regulations as well as fire
protection measures
– Knowledge of the electrical/electronic
regulations and national regulations
Safety instructions
Electric shock, short
DANGER
circuit, fire, explosion
Use of a damaged or defective charger and a
damaged or defective electrical socket, improper use
of the charger or failure to observe the safety
instructions can cause short circuits, electric shocks,
explosions, fires or burns.
e Only use accessories, e.g. power supply and
vehicle cables, that have been approved and
supplied by Porsche.
e Do not use a damaged and/or soiled charger.
Check the cable and plug connection for damage
and soiling before use.
e Only connect the charger to properly installed and
undamaged electrical sockets and fault-free
electrical installations.
e Do not use extension cables, cable reels,
multiple sockets or (travel) adapters.
e Do not modify or repair any of the electrical
components.
e Only work on the charger when the power supply
is disconnected.