Nederman E-PAK 500 DX Hybrid Manuel D'instruction page 41

the bearings are to be replaced every 5 years. See the fan manual for more
information about bearing and grease types.
The bearings are a standard type. Contact Nederman or an authorized
Nederman distributor for replacement of the bearings.
Old grease is to be removed and new grease used. The grease is to meet the
DIN 51825-K2N 40, SKF LGHP 2 or FAG Arcanol Multitop standards.
10.6 Spare parts
Installation, repair and maintenance work is to be carried out by qualified
personnel using only original Nederman spare parts. Contact your nearest
authorized distributor or Nederman for advice on technical service.
10.6.1 Ordering spare parts
See www.nederman.com.
When ordering spare parts always state the following:
• Part number and control number, see the product identification plate.
• Detail number and name of the spare part, see www.nederman.com.
• Quantity of the parts required.
11 Recycling
The product has been designed for component materials to be recycled.
Its different material types are to be handled according to relevant local
regulations. Contact the distributor or Nederman with any queries about
scrapping the product at the end of its service life.
12 Troubleshooting
WARNING! Risk of personal injuries.
Use proper protective equipment when risking exposure to the dust.
WARNING! Risk of electric shock.
Work with electric equipment is to be carried out by a qualified electrician.
WARNING! Risk of electric shock.
Always disconnect the supply voltage with the maintenance switch before any
service, whether mechanical or electrical. Always lock the maintenance switch
in the off position.
WARNING! Risk of personal injuries.
Ensure that there is no vacuum present in the system during service.
WARNING! Risk of personal injuries.
Always disconnect the compressed air supply before any service.
E-PAK 500 DX Hybrid EN
41