Publicité
Les langues disponibles
Les langues disponibles
EN
E-PAK 500 DX Hybrid
10.1
10.2
10.3
38
Service and maintenance of ATEX equipment
To ensure the required level of protection, ensure that the following is
performed:
•
E-PAK 500 DX Hybrid is regularly inspected for damage or malfunction. If
E-PAK 500 DX Hybrid is damaged, it is to be shut down and any explosive
atmosphere removed.
•
There is to be no explosive atmosphere and/or dust layers present when
servicing or inspecting E-PAK 500 DX Hybrid.
•
Only Nederman original spare parts are to be used.
•
E-PAK 500 DX Hybrid is not be covered with thick dust layers (>5 mm).
This is prevented by setting up routines for regular cleaning and including
these in the explosion protection document.
Checks one month after installation and every year
WARNING!
Risk of electric shock.
Always disconnect the supply voltage with the maintenance switch before any
service, whether mechanical or electrical. Always lock the maintenance switch
in the off position.
WARNING!
Risk of personal injuries.
Ensure that there is no vacuum present in the system during service.
WARNING!
Risk of personal injuries.
Always disconnect the compressed air supply before any service.
One month after installation, and then every year, perform the following
checks:
Check all power conductor and ground wire connections. Tighten, if required,
to ensure good contact.
Inspect the integrity of the dust separator.
Ensure that the inside of the unit and the connection ducts are free from
deposits. Build-up of deposits inside the duct system may cause discharge of
static electricity.
Clean the area around the unit and all areas where the collected material is
stored to ensure that there are no dust deposits.
Ensure that there is not any combustible material in the risk area.
Check that all signs/markings regarding safe operation are in place and that
the personnel knows about them.
Emptying the collector bin
WARNING!
Risk of personal injuries.
Ensure that there is no vacuum in the dust separator before removing the
collector bin.
WARNING!
Risk of personal injuries.
Crush hazard. Pay attention when lowering and refitting the collector bin. Use
proper protective equipment.
Publicité
