Publicité
Les langues disponibles
Les langues disponibles
Engine Repairs/Faults
Any repairs requiring professional knowledge should be done by an authorised servicing centre. Any unauthorised intervention may
damage the machine or put your safety at risk.
Engine Failures
Trouble
The engine will not start
When idling, the engine is too fast
The engine will not reach the maximum
capacity
The engine will not stop
Cause
1.
Empty tank
2.
The engine is flooded
3.
Fouled plug, (the carbon residues
on electrodes) too big distance
between the electrodes.
4.
Fouled carburettor or carburettor
jets.
5.
Damaged plug connection or
ignition cable.
6.
Ignition spark missing
1.
Cold engine
1.
Fouled plug, (the carbon
residues on electrodes) too big
distance between the
electrodes.
2.
Fouled carburettor or
carburettor jets.
3.
Fouled air filter
4.
Exhaust, exhaust pipe
5.
The packing ring in the
crankcase leaking
6.
Worn cylinders, pistons, piston
rings
7.
Poor fuel mix (too much oil
8.
Poor ignition
1.
The plug is pale grey with marks of
white-hot (melting drops))
2.
Carbon residue in the ignition area.
54
Trouble shooting
1.
fill up the tank
2.
Close the throttle, try starting
several times, remove the ignition
plug if necessary and dry it.
3.
Clean the plug, check the thermal
value and replace it if necessary
Set 0.6-0.7 mm
4.
Clean the carburettor blow it off
5.
Replace
6.
Check short-circuit knob, the cable
ignition module and replace if
necessary.
Adjust the gap (0,3-0,4 mm).
1.
Heat up slowly, turn down the
choke if necessary.
1.
Clean the plug, check the thermal
value and replace it if necessary
Set 0.6-0.7 mm
2.
Clean the carburettor blow it off
3.
Clean
4.
Remove the exhaust pipe, clean
and remove carbon residues.
5.
Replace
6.
Replace the cylinder, piston or
piston rings, grind cylinder and
piston, install
7.
fill up according to instructions
8.
Set a gap in the ignition module
(0.6-0.7 mm)
1.
Fit in the plug of higher thermal
value.
2.
Clean the cylinder head, piston
bottom and cylinder the engine
block
Publicité
