Güde GBLS 2500 Mode D'emploi page 52

INFO: If the machine is out of regular use for a longer period of time and will not start in the way described above, push the start
injection pump twice or three times first (Fig. d-15) and repeat the beginning with step 2.
Watch the idling position set by locking screw (Fig. k-1). If the machine is idling, it should be smooth and should not be stopped.
Always check the set-up and repair if necessary.
Fig. k
Garden Vac Working Method
1. Start the machine as described in Chapter 12.
2. Before stopping the machine, have it idling for 2-3 minutes for the engine to get cooled. The switch the machine off (Fig. j-4) by
putting the trigger in the "OFF" position.
NOTICE!
If the machine, with the switch having been put in OFF position, (Fig. j-4) will not stop, pull the choke out completely. Then, the
machine will stop because it is supersaturated. Clean the machine and check it for damage.
Refer to the faults description in this manual.
Use of Garden Vac
1. The noise of the machine depends on the speed. Always use the speed required for the job being done.
2. Always wear ear, eye and mouth protection when working with the machine.
A mouth guard will prevent from dust inhalation.
3. Wear tight clothing.
4. Do not use the machine when some parts are defective or missing. All the safety devices should be in good working condition.
There are two options of using the machine:
1. Suction function
This function being used, you can vac leaves, grass and dirt in the collection bag.
2. Blowing function
Using this function, you can blow together leaves, grass or dirt and then to dispose of it at a
time, covering a large area.
NOTICE!
Have an eye on the direction of the blowing. The air pressure may throw the objects and cause
injury to the others. Never point at persons or animals with the stream of air.
52