Commissioning; Remove Car Body; Installing The Receiver Aerial Cable - Reely ROAD Carbon Fighter III Notice D'emploi



8. Commissioning

a) Remove Car Body
Remove the four holding clips of the over-roll bar (2 x
above the front axle; 2x left/right of the tank) and the
two clips at the sides of the rear wheels (see arrows in
figure 1).
Pull the over-roll bars from the side of the holders and
put them vertically. Lift and twist the car body so that it
can be removed from the folded-up over-roll bar.
b) Installing the Receiver Aerial Cable
First put the on/off switch for the receiver (see circle in
figure 2) in the „OFF" position (off).
Open the receiver box (figure 2, item 1) by pulling off
the three clips.
Guide the aerial cable through the receiver box lid and
the aerial tube (see included accessories).
Route the battery connection cable of the on/off switch
out of the receiver box (also see figure 3, item 4).
After closing the receiver box, push the tube into the
holder at the top of the receiver box (see arrow in
figure 2).
Simply let excess cable protrude loosely from the tip
of the aerial tube.
For best range, the aerial cable must protrude from the vehicle vertically.
Never shorten the aerial cable! Never coil the aerial cable! This greatly reduces the range.
42
Figure 1
Figure 2