Commissioning - Reely ROAD 1:10 EP Onroad-Car Audi S5 4WD BL RtR Notice D'emploi

b) Commissioning
The manual for the remote control system is included separately. Always observe all safety information
included in it as well as any other information!
• Only use suitable drive batteries for the vehicle. Never operate the speed controller with a mains adapter, not even
for test purposes.
This vehicle is designed for operation with a 2-cell LiPo drive battery (rated voltage 7.4 V).
When using a drive battery with more cells, there is a danger of fire from overheating of the speed controller.
Apart from this, the vehicle's drive will be overloaded and damaged by this (e.g. differential). Loss of
guarantee/warranty!
The speed controller has an undervoltage recognition for LiPo batteries that is pre-set to 3.0 V per cell. For
changes of these pre-settings, a programming card for the speed controller is required. It can be ordered
as an accessory.
• Always switch on the transmitter first when taking the vehicle into operation. Only then must the vehicle's drive
battery be connected with the speed controller and the speed controller switched on. Otherwise, the vehicle may
show unpredictable responses!
Place the vehicle on an appropriate support before connecting the drive battery so that the wheels can
turn freely.
Check the position of the on/off switch of the speed controller and place it in the "OFF" position (switched
off).
Switch on the transmitter if you haven't done it already. Check its function (e.g. operation display of the
transmitter). Exchange the batteries/rechargeable batteries when they become low.
Put the trimming for the throttle/brake function at the transmitter into the centre position.
Now connect a fully charged drive battery to the speed controller. As already named above, only a 2-cell
LiPo drive battery (rated voltage 7.4V) must be used.
Hold the vehicle, but do not reach into the drive unit. There is a risk of serious injury! Never hold the vehicle
by its wheels!
Only then switch on the speed controller (switch position e.g. labelled "ON").
• Check that the vehicle reacts to remote control commands as expected (steering and drive) before taking it from the
support and placing it on the ground with its wheels.
However, the neutral position and full throttle positions for forward and reverse driving at the speed controller
may have to be programmed first. For this, observed chapter 10. a).
Set the transmitter trim for steering so that the front wheels are about straight. The exact setting for straight
driving can be performed during a drive.
35