Commissioning - Reely ROAD Carbon Fighter Notice D'emploi

b) Commissioning
The manual for the remote control system is included separately. Always observe all safety information
included in it as well as any other information!
• Only use suitable drive batteries for the vehicle (see "Technical Data"). In the case of operation with unsuitable drive
batteries, there is a danger of damaging the vehicle (speed controller, receiver, servos, motor). Never operate the
speed controller with a mains adapter, not even for test purposes.
• Always commission the vehicle according to the following sequence. Otherwise, unpredictable reactions of the
vehicle may result! Also observe chapter 8.
Step 1: Place the vehicle on an appropriate surface so that the wheels can turn freely.
Step 2: Check the position of the on/off switch of the speed controller and place it in the "OFF" position
(switched off).
Step 3: Switch on the transmitter if you haven't done it already. Check its function (e.g. operation display of
the transmitter).
Step 4: Put the switch for receiver power supply to the "OFF" position.
Step 5: Connect the receiver power supply.
Step 6: Put the switch for the receiver power supply in the "ON" position.
Step 7: Connect a fully charged 6-cell LiPo battery (rated voltage 22.2 V) to the speed controller. Ensure
correct polarity (red cable = plus/+, black cable = minus/-).
Step 8: Hold the vehicle, but do not reach into the drive unit. There is a risk of serious injury! Never hold the
vehicle by its wheels! First switch on the speed controller (put the on/off switch of the speed controller in
the "ON" position).
Step 9: Before operating the vehicle, check whether the stationary model reacts as expected to the com-
mands of the remote control.
Set the trimming for throttle/brake at the transmitter so that the engine no longer turns when the lever
(neutral position of the throttle/bas lever at the transmitter) is released (transmitter throttle/braking lever).
Set the trim for steering so that the front wheels are about straight. The exact setting for straight driving can
be performed during a drive.
36