Microsd Card Slot Of The Controller - Tuxhorn tubra-eTherm S Manuel D'installation

Connection of the electric heater
Î Use a shielded cable with a cross section of 3 x 2.5 mm² and a maximum
length of 5 m for connecting the electric immersion heater.
ATTENTION! Damage to the appliance!
Using a cable longer than 5 m can lead to damage to the
device!
Î Make sure the cable length does not exceed 5 m.
Note
Î Connect the shield to the protective earth conductor of the
DeltaTherm ® PV only. To do so, use the clip inside the housing.
Do not connect the shield to the immersion heater.
3.3

MicroSD card slot of the controller

The controller is equipped with a MicroSD card slot.
With a MicroSD card, the following functions can be carried out:
• Store measurement and balance values onto the MicroSD card. After the trans-
fer to a computer, the values can be opened and visualised, e.g. in a spreadsheet.
• Prepare adjustments and parameterisations on a computer and transfer them via
the MicroSD card.
• Store adjustments and parameterisations on the MicroSD card and, if necessary,
retrieve them from there.
• Download firmware from the Internet and install them on the controller
updates
via MicroSD card.
Note
For more information about using a MicroSD card, see page 25.
MicroSD card slot
13