Commissioning - Tuxhorn tubra-eTherm S Manuel D'installation

Resetting the timer:
In order to reset time frames adjusted for a certain day
or combination, proceed as follows:
1. Select the desired day or combination.
Select Reset and confirm the security enquiry
2.
with Yes.
The selected day or combination will disappear from
the list, all its time frames will be deleted.
In order to reset the whole timer, proceed as follows:
Î Select Reset and confirm the security enquiry
with Yes.
All adjustments made for the timer are deleted.
4.2

Commissioning

When the hydraulic system is filled and ready for operation, connect the controller
to the mains.
The controller has to be connected to the sensor module by means of the bus (SM).
The controller runs an initialisation phase in which the operating control LED glows
red.
When the controller is commissioned or when it is reset, it will run a commis-
sioning menu after the initialisation phase. The commissioning menu leads the user
through the most important adjustment channels needed for operating the system.
Commissioning menu
The commissioning menu consists of the channels described in the following. In
order to make an adjustment, adjust the desired value with buttons  and  and
confirm with the centre button (OK). The next channel will appear in the display.
Adjustment mode
Changing a value
Confirming a value
Next parameter
Operation
17