Stalgast 9725110 Notice D'instruction page 22

The main burners do
not work.
Main burners burn
yellow
Wrong bowl tempe-
rature
No spark on the pilot
7. DISPOSING OF USED EQUIPMENT
Information for users about the proper principles of disposal of waste electric and electronic equip-
ment
• Leave the old device in the store where you are buying a new device. Each store has an obligation
to take your old equipment free of charge if you buy new equipment of the same type and in the same
quantity. The only condition is to deliver the equipment to the store at your own expense.
• Take the used device to a collection point. You will find information about the nearest location on the
municipal website or bulletin board of the municipal office.
• Leave the device at the service point. If the repair of the device is uneconomical or impossible for
technical reasons, the service is obliged accept the device free of charge.
• Return used equipment without leaving your house. If you don't have the time or ability to transport
your equipment to a collection point, you can use the services of specialized companies.
Remember! Do not dispose of used equipment along with household waste.
This could cause high fines.
The symbol of the crossed-out waste bin on the product, its packaging or the instruction manu-
al means that the product should not be disposed of to normal waste bins. The user is obliged
to hand over the used equipment to a designated collection point for proper processing.
8. WARRANTY
The seller shall be liable under the warranty or guarantee.
Damage resulting from the formation of lime scale deposits in the device are not subject to repair under the
warranty.
Warranty exchange does not cover such elements as: light bulbs, rubber components, heating elements da-
maged by lime scale, screws and elements undergoing natural wear, e.g. rubber seals and all kinds of mecha-
nically damaged elements. Any damage of components resulting from improper use is also excluded from the
warranty.
The warranty is automatically voided in the event of a broken warranty seal or independent repairs.
Gas pressure is too low
Main burner nozzles are clogged
The gas valve is defective.
Wrong amount of air supplied to the main
burners - requires adjustment of the sleeve at the
main burner nozzle
Soiled main burners - holes
Incorrect placement of the thermostat regulator
sensor.
The gas valve is defective.
Make sure the unit is connected to the mains
Check the wiring connections
Spark generator defective
- 22 -
Please call MAINTENANCE
Please call MAINTENANCE
Please call MAINTENANCE
Connect your device to a 230V
network - plug
Please call MAINTENANCE