Setting In Operation - Installation; Connection; Installation - Bodet Cristalys Opalys 7 NTP Instructions De Mise En Service Et D'utilisation

III - SETTING IN OPERATION - INSTALLATION III - SETTING IN OPERATION - INSTALLATION

3.1 Connection

a. Turn the clock upside down on a table.
Unscrew the anti-theft locking screw.
Push the wall holder opposite the two arrows
to unclip it.
Remove the wall holder on the back of the
clock.
b. Connect the Ethernet network on the RJ45 connector.
Ethernet cable category: 4, 5 or 6 (buildings). In the latter case, use a female wall connector
with a small fl exible male/male RJ45 cable.
The type of synchronisation will have to be programmed in the Technician Menu (see page 28),
particularly the Multicast address which must be the same as that of the server (by default
239.192.54.01).

3.2 Installation

Setting of the table bracket (if supplied) Setting of the table bracket (if supplied) Setting of the table bracket (if supplied)
(in the 2 notches of the wall bracket).
■ Fit the wall bracket using the plugs and screws supplied.
■ Clip the clock in place on the bracket and secure with the anti-theft locking screw provided (see
diag.2).
■ Remove the protective sheet from the front panel and use the anti-static cloth to clean the clock.
Mounting on vertical bracket or ceiling bracket :
■ Cristalys or Opalys clocks can be installed on various types of brackets (ref. 938901, 938907
and 938908). See the installation manual delivered with the bracket.
20
143
100
Reset
Sel.
Anti-theft locking
screw
Diag.: 2