SOLIS CAFFESPRESSO PRO Mode D'emploi page 89

Remove the portafilter and ensure, the tablet has completely dissolved. If the tab-
¥
let has not dissolved, repeat steps 5 to 7 until tablet has dissolved. If the SOLITABS
tablet has dissolved, rinse the portafilter with filter basket with warm water.
If there are any problems during the brewing of the next espresso, please check
µ
the troubleshooting suggestions in the "Troubleshooting" chapter.
∂ Troubleshooting can be found on page 93–95.
The SOLITABS cleaning tablets can be found in good retailers or through
∑
SOLIS-mail.
C LE A n inG t h E S t E A m WA n D
1
from wand after texturing
➊
The steam wand must always be cleaned each time after texturing milk.
Proceed as follows:
¨ Direct the steam wand into the drip tray, and set the selector dial to the steam
position ã . This will clear any remaining milk from inside the steam wand.
Ensure the steam dial is turned back to the centre, in Standby-position. Press the
POWER-button to turn off the appliance and allow it to cool.
Wipe the outside of the steam wand with a damp cloth.
≠
If the steam wand remains blocked, use the pin on the cleaning tool to clear the
Æ
opening.
If the steam wand remains blocked at all, the tip of the steam wand can be re-
➍
moved by using the spanner in the centre of the cleaning tool. Unscrew the tip.
Soak the tip in hot water before using the pin on the cleaning tool to unblock.
∞
Replace the tip back onto the steam wand and secure with the cleaning tool.
2 3
each use
➋
4
➌ ➍ ➎
89