During Operation - Reely SKY Agusta A109 Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• If batteries are used as the power supply of the transmitter, make sure that there is sufficient remaining capacity
(battery tester). If the batteries are empty, always replace the complete set, never replace individual cells.
• To operate your model, always pull out the telescopic aerial completely as the transmitter would otherwise cover a
decisively smaller range and the amplifier of the transmitter would be overloaded significantly.
• Always switch on the transmitter first. Then the flight battery of the model may be connected. Otherwise, the model
might show unpredictable responses and the rotors might start unintentionally!
• Always check if the main rotor and the tail rotor are correctly and securely installed before operating the product.
• Make sure that no objects or body parts are in the range or the suction area of the rotors while they are rotating.
c) During Operation
• Do not take any risks when operating the model! Your own safety and that of your surroundings depend on your
responsibly handling the model.
• Improper operation can cause serious personal injury or material damage! Therefore, during operation, make sure
there is sufficient safe distance to persons, animals or objects.
• Select a suitable area to operate your model plane.
• Fly your model only if your ability to respond is unrestricted. Tiredness or the influence of alcohol or medicine can
lead to false responses.
• Do not fly your model towards spectators or towards yourself.
• Never point the telescopic aerial of the transmitter directly towards the model. This significantly impairs signal
transmission to the model.
• The motor, the speed controller and the flight battery can heat up during operation. For this reason, wait for 10 to 15
minutes before recharging or replacing the flight battery. The drive motor must have cooled down to ambient
temperature.
• Always leave the remote control (transmitter) turned on as long as the model is in operation. After landing, first
disconnect the flight battery or switch off the model. Only then may you switch off the remote control.
• In case of a fault or a malfunction, rectify the problem before using the model again.
• Do not expose your model or the remote control to direct sunlight or excessive heat over a long period of time.
All manuals and user guides at all-guides.com
33

Publicité

Table des Matières
loading

Table des Matières