Above Floor / Free Standing Installation - Kessel Minilift Instructions D'installation, D'utilisation Et D'entretien

3.2 Above floor / free standing installation

Drainage points situated below public sewer level
3. Installation
19
Before installing the Minilift please make
sure that the following steps are taken:
1. Place the flat gasket (#8) over the proper
portion of the quick release mechanism
(#6).
2. Insert the interior rubber seal (#9) inside
the other side of the quick release me-
chanism (#6).
3. Now insert the quick release mechanism
from inside the Minilift chamber through
the pre- drilled hole so that it now sticks
out of the exterior side of the chamber.
4. From the exterior of the chamber, screw on
the locking nut (#7) onto the threaded por-
tion of the quick release mechanism which
will securely fasten the entire fixture.
5. Insert the Minilift pump into the chamber
and make sure that the base of the pump
aligns and securely sits on the guiderails
on the base of the chamber. Now move
the pump forward so that the outlet of the
pump (#4) securely inserts into the quick
release mechanism (#6 & #9). Lock the
pump in place by closing the locking lever
(#5).