Status Code; Erase Current Tx - Honeywell 301 Serie Mode D'emploi

Status Code

These screens display transmission or node status and sensor status for the se-
lected transmitter. This read‐only information can assist service personnel in trou-
bleshooting.
The XNX and XCD gas detectors will report the warning or fault number (iFault-
WarnNumber) in hexadecimal on the third line. These transmitters will also report
the monitoring state (iMonitoringState) in the fourth line. See the transmitter docu-
mentation for interpretation of fault numbers and monitoring states.
1. Tx INFO 001
-Status Codes-
Tx Status 0000h
Monitor State 0001h
Typical display for XNX or XCD
1. Tx INFO 001
-Status Codes-
Tx Status 0000h
Snsr Staus 0000h
Typical display for other transmitters

Erase Current Tx

This function allows the configuration to be erased or the Tx address for the dis-
played component to be changed.
Note: Selecting erase current Tx only erases the current device entry Tx Info con-
figuration. No other data is erased.
1. Tx info
Erase current Tx
Change Tx Adress
33
001