Test Sequence - Honeywell 301 Serie Mode D'emploi

Test Sequence

When test sequence is selected from the main Tests menu, the controller will display the Test sequence
screen.
If Esc is pressed on the keypad, the main Tests menu screen will be displayed. However, to perform system
tests, press any key to proceed to the
This screen tests each component individually and will advance only to the next component when a key is
pressed. This option will display 13 screens. Screens 1, 2, and 3 test Relays, BUZZER and LEDs.
The following six screens prompt the user to press the keypad buttons, in turn: left, right, up, down, Silence,
Enter and Esc. The system will not advance until a key is pressed.
The system then moves to the Display test. When the blank screen is displayed, it is testing for display pixels.
Press any key to proceed to the next step.
The final test that the system performs is a network communication test:
Once these tests have begun, do not interrupt or stop them.
When the system has completed the test, it displays the final Tests screen. Press any key to return to the main
Tests menu.
107
Test sequence
Relays activated
Any key to continue
Esc to quit
Test sequence
Buzzer activeted
Any key to continue
Esc to quit
Test sequence
Press "left"
Esc to quit
Test sequence
Display test
Any key to continue
Esc to quit
Test sequence
Test Network comm
9600 bauds
Channel 1 PASSED
Test sequence
Test done
Any key to continue
first test screen.