AL-KO solo 636 Mode D'emploi page 47

8. MAINTENANCE AND STORAGE
– Start the engine and run it idle until it uses
up all the fuel that is left in the tank and the
carburettor.
– Remove the spark plug after the engine
cools.
– Pour a teaspoon of (new) 2-stroke engine oil
into the spark plug slot.
– Pull the starter grip several times to deliver oil
to the cylinder.
– Replace the spark plug with the piston in
the dead end upper position (visible from the
spark plug slot when the piston is at maxi-
mum stroke).
469601_a
Restarting work
When you wish to start using the machine again:
– Remove the spark plug.
– Pull the starter rope a few times to eliminate
excess oil.
– Check the spark plug as described in chapter
CHECKING THE SPARK PLUG (Fig.
– Prepare the machine as indicated in the pa-
ragraph entitled 7. USING THE
24).
MACHINE.
47