AL-KO solo 636 Mode D'emploi page 46

en
Chain maintenance table
CAUTION!
The specifications of the chain and the bar homologated for this machine are shown in
the "EC Conformity Statement" provided. Do not use other types of chains or bars for
safety reasons.The table gives the sharpening data for different types of chains, but this
does not mean you can use different chains from the homologated one.
Chain pitch
inches
3/8 spec
0.325
3/8
0.404
BAR MAINTENANCE (Fig. 26)
To avoid asymmetrical wear on the bar, make
sure it is turned over periodically.
To keep the bar in perfect working order, proceed
as follows:
– grease the bearings on the nose sprocket (if
present) with the syringe;
– clean the bar groove with the scraper (not in-
cluded);
– clean the lubrication holes;
– with a flat file, remove burr from the edges
and level off the guides.
Replace the bar whenever:
– the groove is not as deep as the height of the
drive links (which must never touch the bot-
tom);
– the inside of the guide is worn enough to
make the chain lean to one side.
EXTRAORDINARY MAINTENANCE
All maintenance operations not foreseen in this
manual must be performed exclusively by your
dealer.
All and any operations performed in unauthorised
centres or by unqualified persons will totally inva-
lidate the warranty.
STORAGE
46
Limiter tooth level (a)
mm inches
9.32 0.018
8.25 0.026
9.32 0.026
10.26 0.031
8. MAINTENANCE AND STORAGE
a
mm
0.45
0.65
0.65
0.80
After every period of work, clean the machine tho-
roughly to remove all dust and debris, and repair
or replace any faulty parts.
The machine must be stored in a dry place away
from the elements and with the bar cover correctly
fitted.
LONG PERIODS OF DISUSE
If you are not going to use the machine
for a period of more than 2-3 months,we
recommend you do a few things before
putting it away. This will make it easier
when you want to use the machine again
and will also prevent permanent damage
to the engine.
Storage
Before putting the machine away:
– Unscrew the two nuts, remove the guard and
remove the chain and rod.
– Empty the oil tank, fill with about 100-120 cc
of specialist liquid detergent and plug the cap.
– Fit the guard back on without tightening the
nuts.
– Start the engine and keep it running until all
detergent is used.
File diameter (d)
d
inches mm
5/32 4.0
3/16 4.8
13/64 5.2
7/32 5.6
469601_a