Changing The Nozzle - WAGNER FineCoat 8800 Mode D'emploi

Masquer les pouces Voir aussi pour FineCoat 8800:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9. Switch the unit off.
10. Clean the outer surfaces of the paint container and
paint spray gun with a cloth soaked in solvent or
water.
Note: Do not leave the FineCoat spray gun immersed
in solvent for extended periods! (The seals and air
pipe on non-return valve may swell, preventing them
from functioning properly.)
11. Unscrew adjusting ring, remove air cap and spring
plate. Unscrew nozzle. Clean air cap, tip and needle
with brush and solvent or water.
Note: Never use sharp metal objects to clean the
nozzles or air channels of the FineCoat spray gun.
12. Apply a fine coat of silicone-free oil to the marked
areas.
13. If the paint spray gun is not used for any length of
time, it should be cleaned and protected by applying
a fine coat of silicone-free oil.

Changing the nozzle

Note: Make sure that the air cap, the tip and the needle
have identical markings.
1. Remove the adjusting ring, the air cap and the spring
plate (fig. 13).
2. Fig. 14 – Loosen the needle seal with the open-end
wrench (1). Remove the material adjusting knob (2)
and the pressure spring (3). Open trigger of the spray
gun to facilitate needle removal (4).
All manuals and user guides at all-guides.com
g
3. Remove the needle (5) (fig. 15).
4. Remove the tip with the enclosed special socket
18
3
2
5
wrench (fig. 16).
Reassemble with the new nozzle set in reverse order.
Attention: The needle seal screw connection must be
readjusted after reassembly.
1
4

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Finecoat 9800

Table des Matières