Declaration Of Conformity - WAGNER FineCoat 8800 Mode D'emploi

Important notes on product
liability
As a result of an EC regulation being effective as from
January 1, 1990, the manufacturer shall only be liable
for his product if all parts come from him or are
released by him, and if the devices are properly
mounted and operated.
If the user applies outside accessories and spare
parts, the manufacturer's liability can fully or partially
be inapplicable; in extreme cases usage of the entire
device can be prohibited by the competent authorities
(employer's liability insurance association and factory
inspectorate division).
Only the usage of original WAGNER accessories and
spare parts guarantees that all safety regulations are
observed.

Declaration of conformity

Herewith we declare that the supplied version of
WAGNER FC 8800, 230 – 240 V, 50 Hz
WAGNER FC 9800, 230 – 240 V, 50 Hz
complies with the following provisons applying to it:
73/23 EEC, 89/336 EEC, 89/392 EEC.
Applied harmonized standards,
in particular:
EN-292-1/-2, EN-55014-1, EN-60555, EN-60335
Applied national technical standards and specifications,
in particular:
––––––––––––
Date: 10. 2. 2000
Executive Officer /Signature
All manuals and user guides at all-guides.com
GB
Head of Development
56
Warranty
This unit is covered by our warranty on the following
terms:
We will at our discretion repair or replace free of charge
all parts which within 24 months in single-shift, 12
months in 2-shift or 6 months in 3-shift operation from
date of receipt by the Purchaser are found to be wholly
or substantially unusable due to causes prior to the
sale, in particular faulty design, defective materials or
poor workmanship.
The terms of the warranty are met at our discretion by
the repair or replacement of the unit or parts thereof.
The resulting costs, in particular shipping charges, road
tolls, labour and material costs will be borne by us
except where these costs are increased due to the
subsequent shipment of the unit to a location other than
the address of the purchaser.
This warranty does not cover damage caused by:
Unsuitable or improper use, faulty installation or
commissioning by the purchaser or a third party, normal
wear, negligent handling, defective maintenance,
unsuitable coating products, substitute materials and
the action of chemical, electrochemical or electrical
agents, except when the damage is attributable to us.
Abrasive coating products such as redlead, emulsions,
glazes, liquid abrasives, zinc dust paints and similar
reduce the service life of valves, packings, spray guns,
tips, cylinders, pistons etc. Any wear resulting from the
aforementioned causes is not covered by this warranty.
Components not manufactured by Wagner are subject
to the warranty terms of the original maker.
The replacement of a part does not extend the warranty
period of the unit.
The unit should be inspected immediately upon receipt.
Any apparent defect should be notified to us or the
dealer in writing within 14 days from date of sale of the
unit.
The right to commission warranty services to a third
party is reserved.
Warranty claims are subject to proof of purchase by
submitting an invoice or delivery note. If an inspection
finds damage not covered by the present warranty, the
repair will be carried out at the expense of the
purchaser.
Note that this warranty does not in any way restrict
legally entitled claims or those contractually agreed to in
our general terms and conditions.
Subject to modifications · Printed in Germany
J. Wagner GmbH