Changing The Material Feed Pump Position - WAGNER HC 35 G Mode D'emploi

2.1 Operating position II (fig. 9)
Swivel material feed pump to a slanted (45°) postion if
using the container suction system (accessory). In this
position, there is open space under the material feed
pump.
4.2 Changing the material feed pump
position
Be careful, as the moving parts of the
swivel mechanism can crush fingers
and feet.
Danger
1. Grip handle (fig. 10, item 1) with one hand.
2. Pull retention pin (2) with the other hand.
3. Swivel material feed pump up or down to the desired
position, until the retention pin (2) locks into the new
position.
HC 35 G • HC 45 G • HC 55 G
g
1
Starting operation
2
37