Elvox ECA8 Manuel D'installation Et D'utilisation page 21

TRIMMER
TR1-PAUSE: regulates the pause time (the time the gate remains still before closing automatically) which varies from 1 to 120 seconds.
TR2-FORCE/M1 TR3-FORCE/M2: regulates the torque of the motors. For motors equipped with a clutch or for oil-hydraulic motors it
is necessary to rotate the trimmers to the maximum setting (a complete clockwise rotation).
TR4-SLOSP: (slow-down speed) regulates the speed during the slow-down phase, which can be regulated within the safety parame-
ters. By regulating the trimmer to the maximum setting (a complete clockwise rotation), slow-down does not take place (see learning
procedure without slow-down)
Trimmer
TR1-PAUSE
TR2-FORCE/M1
TR3-FORCE/M2
TR4-SLOW
RADIO CONTROLS LEARNING
The EC 80 equipment is equipped with a built-in decoder that is able to memorise up to 128 rolling code remote controls or 128 fixed
code remote controls.
The first remote control learned by new equipment or after all learned remote controls have been deleted determines the type of re-
mote control (rolling code or fixed code)
Radio control memorisation (START function)
When the gate is closed, press the P2 button and hold it down until the PROG-DL8 LED starts to flash. Release button P2.
Within 10 seconds, press the button of the remote control that you want to associate with the START command. The completion of the
learning process will be indicated by the simultaneous blinking of the PROG-DL8 LED, the flashing light and the pilot lamp, followed
by the switching off of the PROG-DR8 LED.
Second channel radio code memorisation (2CAN Out or Pedestrian Opening function)
Repeat the process for each remote control to be memorised.
When the gate is closed, press button P2 and hold it pressed until the PROG-DL8 LED starts to flash; don't release the button and wait
until the flashing speeds up. Release button P2.
Within 10 seconds press the button of the remote control button that you want to be associated with the 2CAN output (if dip3 = OFF)
or with the pedestrian opening command (if dip 3 = ON). The completion of the learning process will be indicated by the simultaneous
blinking of the PROG-DL8 LED, the flashing light and the pilot lamp, followed by the switching off of the PROG-DR8 LED.
Repeat the process for each remote control to be memorised.
Deleting all learned radio controls
When the gate is closed, press button P2 and hold it pressed until the PROG-DL8 LED starts to flash; don't release the button and wait
until the flashing speeds up; don't release the button and wait until the flashing becomes very fast; don't release the button. The dele-
tion of ALL learned radio controls will be indicated by the simultaneous blinking of the PROG-DL8 LED, the flashing light and the pilot
lamp, followed by the switching off of the PROG-DR8 LED.
PHOTOCELL TEST
To enable the photocell test function, power up the transmitter through the 2CAN output (see diagram), set dip 3 to ON and dip 8 to
ON. This way the photocell test will be performed at the end of each opening manoeuvre.
If the test is failed, the next closing manoeuvre will NOT be performed and two warning flashes will be emitted by the PROG-DL8 LED
and the AUX output.
PROGRAMMING
Function
Pause time
Motor 1 force
Motor 2 force
Slow-down sp.
Range
From 1 to 120 sec
From 20 to 100%
From 20 to 100%
From 0 to 100%
21/36
Special functions
-
MAX: oil-hydraulic
MAX: oil-hydraulic
MAX: slow-down OFF
GB