Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
WITHOUT SLOW-DOWN
•
Regulator trimmer TR4 (SLOSP – slow-down speed) to the maximum setting
•
Close the gate completely.
•
Press the P1 learning button for at least 3 seconds
•
The PROG-DL8 LED starts flashing
•
Do not release button P1; keep it pressed for another 3 seconds
•
The PROG-DL8 starts to flash at a higher frequency
•
Release button P1
•
Press START, button P3 (AP/CH - open/close):
• The first leaf begins to open at standard speed
Without LS card: When the leaf has opened completely, press START
With LS card:
Wait until the leaf opens completely
• The second leaf begins to open at standard speed
Without LS card: When the leaf has opened completely, press START
With LS card:
Wait until the leaf opens completely
• The second leaf begins to close at standard speed
Without LS card: When the leaf has closed completely, press START
With LS card:
Wait until the leaf closes completely
• The first leaf begins to close at standard speed
Without LS card: When the leaf has closed completely, press START
With LS card:
Wait until the leaf closes completely
•
Press START: the first leaf begins to open and as soon as you decide that the leaf offset time is sufficient, press START again: the
second leaf starts to open
•
Press START: the second leaf begins to close and as soon as you decide that the leaf offset time is sufficient, press START again:
the first leaf begins to close
- Wait until the PROG-DL8 LED turns off.
- Learning finished.
3. Single-leaf learning procedures
The single-leaf procedures are used to configure single-leaf gates
WITH SLOW-DOWN
•
Close the gate completely.
•
Press the P1 learning button for at least 3 seconds
•
The PROG-DL8 LED starts flashing
•
Do not release button P1; keep it pressed for another 3 seconds
•
The PROG-DL8 starts to flash at a higher frequency
•
Do not release button P1; keep it pressed for another 3 seconds
•
The PROG-DL8 starts to flash at a higher frequency
•
Release button P1
•
Press START, button P3 (AP/CH - open/close):
•
The first leaf begins to open at standard speed
When you decide to start the slow-stroke phase, press START
The slow-stroke phase starts
Without LS card: When the leaf has opened completely, press START
With LS card:
Wait until the leaf opens completely
•
The first leaf begins to close at standard speed
When you decide to start the slow-stroke phase, press START
The slow-stroke phase starts
Without LS card: When the leaf has closed completely, press START
With LS card:
Wait until the leaf closes completely
- Wait until the PROG-DL8 LED turns off.
- Learning finished.
PROGRAMMING
18/36
Publicité
Table des Matières
