Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
MAINTENANCE
• To ensure the efficiency of the product it is imperative that competent, professional personnel carry out maintenance within the time li-
mits established by the installer, the manufacturer and the legislation in force.
• Maintenance activities, repairs and replacement of parts must be duly documented. The documentation must be kept by the user so that
it is available for the relevant competent personnel.
• Always disconnect the equipment from the power supply by means of the main switch or by removing the plug before performing main-
tenance or cleaning.
• If the power is ON for operation checks, check or disable all control devices (radio controls, push-button panels etc.) with the exception
of the device used by the maintenance engineer.
NOTE: Compliance with Machinery Directive 2006/42 EC: when you have installed the equipment, you must complete a Declaration of Con-
formity and a Scheduled Maintenance Plan and then hand over copies of these documents to the user.
SCHEDULED MAINTENANCE
The maintenance operations recommended for the electrical system are as follows:
Operation
Check the efficiency of the detection and anti-crushing devices (photocells, detector, safety edges) and of the
controls.
Check the efficiency of the electrical system and test the efficiency of the automatic differential overload switch
protecting the electrical system.
Check the inside of the electronic equipment housing and clean out any insects, dirt or dampness.
Check the efficiency of the remote control batteries. Change spent batteries.
Remove obstacles such as branches or bushes which might be permanently blocking the photocell beam.
WARNINGS FOR THE USER
-
Carefully read all instructions and documentation enclosed.
-
This product must be used exclusively as specified in design, any other use is to be considered improper and therefore hazardous.
-
The information in this manual and in the enclosed documentation may be subject to modification without notice. It is supplied as a gui-
deline for product application.
-
In case of a fault and/or poor operation of the automatic system, disconnect it from the mains by means of the main switch and con-
tact professionally qualified personnel or an authorised service centre for assistance. Never attempt to repair or intervene directly.
-
Have the general operation of the automatic system and the safety devices checked once a year by qualified personnel.
The instruction supplied are an integral and essential part of the product and must be read carefully since they contain important warnings
for use and maintenance. These instructions must be retained and delivered to all possible future users.
The EC80 equipment has been designed to control the operation of 230 V AC electromechanical actuators for the automation of swing gates.
It is prohibited to use the product for an improper purpose or for purposes other than those intended. Any other use is improper and the-
refore hazardous. It is prohibited to tamper with or modify the product.
You should ask the company that installs the automation to provide a scheduled maintenance plan in accordance with the regulations for
this type of equipment (for EC countries: Machinery Directive 2006/42/EC). Perform maintenance at the recommended intervals, see the
maintenance manual issued by the installer.
Only suitably skilled technicians trained on the product are authorised to connect up, test, start up, clean and maintain this product.
The user is not permitted to operate either on the system or control unit, or inside the electrical housing. In the event of an operating fault
or a mains power failure you can OPERATE THE GATE BY HAND (for instructions, see the actuator installation manual)
SAFETY PRECAUTIONS
1. Keep out of the gate's operating range whilst it is moving: wait until the manoeuvre has finished.
2. Operate the gate only when it is completely visible and free from obstacles.
3. Do not allow children or animals to play or stand near the gate. Do not allow children to play with the controls or with the remote con-
trol device.
4. Do not oppose the gate movement since it might cause dangerous situations.
5. Do not touch the equipment with wet hands and/or feet.
PROGRAMMING
22/36
Average frequency
6 months
6 months
6 months
6 months
6 months
Publicité
Table des Matières
