Elvox ECA8 Manuel D'installation Et D'utilisation page 16

GB
PROGRAMMING
After a reset or after powering up the card, the travel time of the first closing manoeuvre is increased by approximately 50
seconds, to enable the completion of the manoeuvre in all cases.
In configurations that require the presence of limit switches, during the travel path learning procedure the type of the limit switch
contacts is also detected and memorised (N.O. or N.C). Limit switches of different type can be used for the two gate leaves.
1. Reduced learning procedures
The reduced learning procedures memorises only the slow-down spaces, whereas the leaf delays are fixed at 2 seconds on opening and
4 seconds on closing
WITH SLOW-DOWN
- Close the gate completely
- Press the P1 learning button for at least 3 seconds
- The PROG-DL8 LED starts flashing
- Release button P1
- Press START, button P3 (AP/CH – open/close):
• The first leaf begins to open at standard speed
When you decide to start the slow-stroke phase, press START
The slow-stroke phase starts
Without LS card: When the leaf has opened completely, press START
With LS card: Wait until the leaf opens completely.
• The second leaf begins to open at standard speed
When you decide to start the slow-stroke phase, press START
The slow-stroke phase starts
Without LS card: When the leaf has opened completely, press START
With LS card: Wait until the leaf opens completely
• The second leaf begins to close at standard speed
When you decide to start the slow-stroke phase, press START
The slow-stroke phase starts
Without LS card: When the leaf has closed completely, press START
With LS card: Wait until the leaf closes completely
• The first leaf begins to close at standard speed
When you decide to start the slow-stroke phase, press START
The slow-stroke phase starts
Without LS card: When the leaf has closed completely, press START
With LS card: Wait until the leaf closes completely
- Wait until the PROG-DL8 LED turns off.
- Learning finished.
WITHOUT SLOW-DOWN
- Regulator trimmer TR4 (SLOSP – slow-down speed) to the maximum setting
- Close the gate completely
- Press the P1 learning button for at least 3 seconds
- The PROG-DL8 LED starts flashing
- Release button P1
- Press START, button P3 (AP/CH – open/close):
• The first leaf begins to open at standard speed
Without LS card: When the leaf has opened completely, press START
With LS card: Wait until the leaf opens completely
• The second leaf begins to open at standard speed
Without LS card: When the leaf has opened completely, press START
With LS card: Wait until the leaf opens completely
PROGRAMMING
16/36