Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• The second leaf begins to close at standard speed
Without LS card: When the leaf has closed completely, press START
With LS card:
Wait until the leaf closes completely
• The first leaf begins to close at standard speed
Without LS card: When the leaf has closed completely, press START
With LS card:
Wait until the leaf closes completely
- Wait until the PROG-DL8 LED turns off.
- Learning finished.
2. Complete learning procedures
The complete procedures enable the system to learn the leaf delays as well
WITH SLOW-DOWN
- Close the gate completely
- Press the P1 learning button for at least 3 seconds
- The PROG-DL8 LED starts flashing
- Do not release button P1; keep it pressed for another 3 seconds
- The PROG-DL8 starts to flash at a higher frequency
- Release button P1
- Press START, button P3 (AP/CH - open/close):
• The first leaf begins to open at standard speed
When you decide to start the slow-stroke phase, press START
The slow-stroke phase starts
Without LS card: When the leaf has opened completely, press START
With LS card:
Wait until the leaf opens completely
• The second leaf begins to open at standard speed
When you decide to start the slow-stroke phase, press START
The slow-stroke phase starts
Without LS card: When the leaf has opened completely, press START
With LS card:
Wait until the leaf opens completely
• The second leaf begins to close at standard speed
When you decide to start the slow-stroke phase, press START
The slow-stroke phase starts
Without LS card: When the leaf has closed completely, press START
With LS card:
Wait until the leaf closes completely
• The first leaf begins to close at standard speed
When you decide to start the slow-stroke phase, press START
The slow-stroke phase starts
Without LS card: When the leaf has closed completely, press START
With LS card:
Wait until the leaf closes completely
• Press START: the first leaf begins to open and as soon as you decide that the leaf offset time is sufficient, press START again: the se-
cond leaf begins to open
• Press START: the second leaf begins to close and as soon as you decide that the leaf offset time is sufficient, press START again: the
first leaf begins to close
- Wait until the PROG-DL8 LED turns off
- Learning finished.
PROGRAMMING
17/36
GB
Publicité
Table des Matières
