Technical Data; Machine Data - Stiga Titan Mode D'emploi

All manuals and user guides at all-guides.com
1 GENERAL
This symbol indicates CAUTION.
Serious personal injury and/or damage
to property may result if the
instructions are not followed carefully.
You must read these instructions for use
and the accompanying pamphlet
"SAFETY INSTRUCTIONS"
carefully, before starting up the
machine.
Contaminants must not enter the
hydraulic system or the fuel system.
This causes serious damage to
components of the systems.
1.1 SYMBOLS
The following symbols appear on the machine.
They are there to remind you of the care and atten-
tion required during use and maintenance.
This is what the symbols mean:
Caution!
Read the instruction manual and the safety
manual before using the machine.
Caution!
Watch out for discarded objects. Keep on-
lookers away.
Caution!
Always wear hearing protectors.
Caution!
The machine, equipped with original ac-
cessories, must not be driven in any direc-
tion on slopes with a gradient greater than
10º.
Caution!
Risk of crushing injuries. Keep all body
parts away from the articulated steering
when the engine is running.
Caution!
Risk of burn injuries. Do not touch the si-
lencer/catalytic converter.
1.2 References
1.2.1 Figures
The figures in these instructions for use are num-
bered 1, 2, 3, etc.
Components shown in the figures are marked A, B,
C, etc.
A reference to component C in figure 2 is written
"2:C".
ENGLISH
1.2.2 Headings
The headings in these instructions for use are num-
bered in accordance with the following example:
"1.3.1 General safety checks" is a subheading to
"1.3 Safety checks" and is included under this
heading.
When referring to headings, only the number of the
heading is normally specified. E.g. "See 1.3.1".
1.3 Abbreviations
Abbreviations are used in these instructions for
use. Their meanings are given in the table below:
Abbre- Meaning
viation
PTO Output for driving front mounted
accessory.
PTO1 Control for operation of output for
driving front mounted accessory.
F Implement lifter
F1 Control for operating the implement
lifter.
L Output for auxiliary functions on front
mounted accessory. See fig. 1.
L1 Control for operating L.
R Output for auxiliary functions on front
mounted accessory. See fig. 1.
Re Output for auxiliary functions on rear
mounted accessory. See fig. 5.
R1 Control for operating R and Re

2 TECHNICAL DATA

2.1 Machine data

Data Titan 20 B 26 B
Engine out-
14,7 19,3
put, kW
Drive PTO Belt Belt
Speed, km/h 0-20 0-20
Weight, kg 590 600
Engine oil, 2.8 li-
volume tres
Engine oil,
grade
Hydraulic oil 20 litres SAE 10W-30
Oil
4x0.17 litres SAE50/API90
wheel motors
Ambient
temperature
Fuel Diesel (EN590:96)
Tank volume
GB
26 H 26 HS
19,3 19,3
Hy- Hy-
drau- drau-
lics lics
0-20 0-24
610 610
3.4 litres
See "5.3"
Down to -20°C.
42 litres
75