Section 1 Safety; Personal Protective Equipment; Training - Thermo Scientific EK45 Mode D'emploi

Section 1 Safety

Personal Protective
Equipment

Training

1-2
Always turn the cooler off and disconnect the supply voltage from its
power source before moving performing any service or maintenance
procedures. Ensure cooler is at a safe temperature before handling.
Never place the cooler in a location or atmosphere where excessive heat,
moisture, or corrosive materials are present.
Leave cooler in an upright position at room temperature (~25°C) for 24
hours before starting. This will ensure the lubrication oil has drained
back into the compressor.
Other than water, before using any fluid, or when performing mainten-
ance where contact with the fluid is likely, refer to the manufacturer's
MSDS and EC Safety Data sheet for handling precautions.
The cooler's evaporator coil must not be kinked, bent or twisted. This
can lead to evaporator coil damage and a refrigeration leakage.
Ensure, that no toxic gases can be generated by the fluid. Flammable
gases can build up over the fluid during usage.
Never use corrosive or flammable fluids with this cooler. Use of these
fluids will void the manufacturer's warranty.
Never operate the cooler with panels removed.
Transport the cooler with care. Sudden jolts or drops can damage its
components.

Do not clean the cooler with solvents, only use a soft cloth and water.
Refer service and repairs to a qualified technician.
Performance of installation, operation, or maintenance procedures other
than those described in this manual may result in a hazardous situation
and will void the manufacturer's warranty.
The are no special personal protective equipment requirements needed to
perform normal operation. We do recommend wearing eye protection and
gloves.
The user must review and understand all the sections in this manual before
operating the cooler.










Thermo Scientific
