Thermo Scientific EK45 Mode D'emploi page 43

Controller
Thermo Scientific
Operation
Section 4
The controller displays the current sensor temperature.
To view the setpoint press the SET key. The change the setpoint press and
hold the SET key for two seconds. Use the
to lower the displayed setpoint value. Press the SET key again to store and
display the new setpoint value. The controller automatically displays to cur-
rent temperature.
NOTE If no entry is made within three seconds the value shown in the dis-
play automatically switches back to the current temperature and the controller
returns to the previous setpoint value.
EK 90 only
Fault display light illuminates to indicate a fault has occurred.
Reset button resets the cooler after a fault or interruption.
°C
SET
key to raise or the

key
4-1