Cleaning The Housing And Nozzles; Storage; Troubleshooting - Cleanmaxx C-320-70 Mode D'emploi

EN
10. Put the lid on the dust container so that the arrow symbol on the dust container
points to the
arrow sym- bol should now be pointing to the
11. Put the dust container in the device. Make sure that it audibly locks into place.
Cleaning the HEPA exhaust air fi lter
The HEPA exhaust air fi lter is situated behind the protective grill on the back of the
vacuum cleaner.
D
3. Brush or wipe the fi lter compartment if required.
4. Place the exhaust hatch with fi lter in the device and close the hatch. The hatch must
audibly lock into place.

Cleaning the housing and nozzles

• If needed, clean the housing with a damp, soft cloth.
• Regularly remove hair and lint from the nozzles.

Storage

Troubleshooting

If the device should stop working properly, fi rst check whether you are able to correct
the problem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The vacuum clea-
ner has no suction
power.
symbol on the lid. Close the lid by turning it as far as it will go. The
1. Pull down the exhaust hatch latch with fi lter (D) and
remove the hatch simultaneously.
2. Tap it out over a garbage bin. If necessary, clean it with
a soft brush. You can also rinse the fi lter out under clear,
lukewarm warm water.
Attention: Do not use any cleaning products!
Next, shake off any surplus water and leave the fi lter to air
dry completely before replacing it in the device.
• For storage you hook the fl oor nozzle into the holder on
the back of the device (see fi gure) and close down the
telescopic tube as far as it will go.
• Store the vacuum cleaner in a cool dry indoor room where
it cannot be reached by children or animals.
Possible cause/solution
• Is the mains plug not correctly connected with a socket?
Correct the position of the mains plug.
• Is the socket defective? Try another socket.
• Check the fuse for your mains connection.
22
symbol.