Cleaning The Housing And Nozzles - Cleanmaxx VC-S1001 Mode D'emploi

6. Allow all parts to dry completely in the air before you insert them again.
CAUTION! Do not under any circumstances use a hair dryer. Do not insert
the fi lter under any circumstances if it is still damp!
7. Place the fabric tape around the fi lter and close the Velcro fastener.
8. Place the fi lter back into the dust container so that it sits directly on the housing wall
all the way round.
CAUTION! Never use the vacuum cleaner without the fi lter inserted.
9. First place the dust container at the bottom of the device and then fl ip it shut. The
dust container must be fi rmly locked in place at the top and bottom of the device.

Cleaning the Housing and Nozzles

• Clean the housing if necessary using a damp, soft cloth. Dry it with a soft cloth.
• Remove hair and fl uff from the nozzles at regular intervals.
Storage
3. Carefully remove the fi lter (5) and empty the dust con-
tainer.
4. A piece of fabric tape is attached around the fi lter. Open
the Velcro fastener of the tape and gently tap out the fi lter
and the tape.
5. Wash the dust container, the fi lter and the fabric tape if
necessary under cold, running water.
CAUTION! Do not wash the fi lter and the fabric
tape in the washing machine.
• If you have attached the telescoping rod (13), you can
wind the cable over the two cable holders (1) for the pur-
pose of storage.
• Store the vacuum cleaner in a cool, dry place which is out
of the reach of children and animals.
22