Declaration Of Wireless Dimmer In The Fs20 Address System; Assigning Additional Addresses/Address Types; Deleting Addresses Or Address Types - Conrad FS20 DI20-3 Notice D'emploi

10. Declaration of wireless dimmer in the FS20
address system
The address assignment of the FS20 wireless switching system allows you to assign the
wireless dimmer to its address system (single addresses, functional groups, local and global
masters). A detailed layout of the address system is included in the operating instructions of
each transmitter of the FS20 wireless switching system.
a) Assigning additional addresses/address types
Within the address system of the FS20 wireless switching system up to 4 address types can
be assigned to the wireless dimmer. It is thus possible to control the wireless dimmer with
different transmitters using the same or different address types.
Detailed information concerning the address system is included in the operating instructions
of each remote control of the FS20 wireless switching system.

In order to assign additional address types to the wireless dimmer, repeat the
steps described in chapter 8. The wireless dimmer can store a list of up to four
addresses or address types.
b) Deleting addresses or address types
To delete a receive channel from the list in memory, set the wireless dimmer to programming
mode and hold down the buttons assigned to the wireless dimmer on the respective remote
control for more than 0.4 seconds.

Then programming mode will be quitted automatically and the channel is no
longer in the address list of the wireless dimmer.
41