Programming; Control Of Basic Functions - Conrad FS20 DI20-3 Notice D'emploi

b) Programming
There are two ways to set the wireless dimmer to programming mode:
1. Use a thin non-conductive object to press the sunk-in push button at the top of the housing
while you are connecting the wireless dimmer to the power supply.
The pilot LED on the wireless dimmer will flash when programming mode is activated.
2. If the wireless dimmer has already been connected to the power supply, press the push
button for at least 15 seconds.
The pilot LED on the wireless dimmer will flash when programming mode is activated.
Now press a button of the desired pair of buttons on the remote control. Once the wireless
dimmer has received the code, the pilot LED will stop flashing.

On demand, the set programming can be replaced by pressing another button
on the remote control or another remote control channel. Proceed as described
above.
c) Control of basic functions
• Using the remote control
Switching on:
Switching off:
Dimming up:
Dimming down:
If you press the right button on the remote control or the button of the wireless dimmer for
more than 0.4 seconds while the light is switched off, the wireless dimmer will not start at the
brightness stored but at the lowest level of brightness.
As long as the button is held down, the wireless dimmer slowly increases brightness.
If you press the left button on the remote control for more than 0.4 seconds while the light
is switched off, the wireless dimmer will start at the highest level of brightness and slowly dim
down.
36
Shortly press the right button of the programmed pair of buttons.
Shortly press the left button of the programmed pair of buttons.
With the light switched on, press the right button of the programmed
pair of buttons for more than 0.4 seconds to increase brightness.
With the light switched on, press the left button of the programmed
pair of buttons for more than 0.4 seconds to decrease brightness.